Hello: I recently decided to give Debian ARM a try on my nslu2 using the latest, debian-armel-5.0rc2.zip. Kudos to all those involved -- very cool.
Here are some the issues I've run into: First try: reset to Linksys firmware, configure network in full per my requirements, flash to Debian installer via linksys webgui, install to Quantum Fireball 3G disk Issues -- wouldn't recognize the disk in USB port 1 so moved to USB2, extremely slow install (> 12 hours), my guess is this drive's performance was just not up to snuff since its so old, and upon reboot -- pingable but no ssh...even after leaving it sit for a few hours. Nothing in the logs. Second try: same disk used, this time not pingable at all Nothing in the logs eluding to the issue. Third try: Used a 1G flash stick in port (much faster install! Closer to the 4 hours but still more like about 6-8hrs) Issues: unit came up fine, made many of the suggested modifications for removing unneeded modules, installed ntpdate, adjusted fstab to reduce writes to flash.... After reboot, the unit loads, NIC stays up, but as soon as it mounts the flash stick, the ethernet goes down and I never get network connectivity nor see the LED become lit. I see nothing in the logs that its even attempted booting up I followed instructions to remove hotplug from interfaces and ensured auto eth0 is present, made sure the symlink was present, and reviewed fstab -- which ended up being changed to the below -- why I do not know, nor if it is remotely correct with the UUID it chose. I've tried going back to what I thought was in my original fstab with no success as well as removed fsck check and still no love. Can anyone advise what might be amiss here? Or should I try being a bit more patient and leave it sit a few hours? Thanks for the help! Keep up the good work! Here is what I noted my fstab had been modified to upon rebooting... # /etc/fstab: static file system information. # # <file system> <mount point> <type> <options> <dump> <pass> proc /proc proc defaults 0 0 # /dev/sda1 UUID=16bfd604-a255-438b-af3f-c786ff8ac85f / ext3 relatime,errors=remount-ro 0 1 # /dev/sda5 UUID=4cb02dee-d46e-42ff-b112-f6d0f2e3484d none swap sw 0 0 /dev/scd0 /media/cdrom0 udf,iso9660 user,noauto,exec,utf8 0 0 -- To UNSUBSCRIBE, email to debian-boot-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
