On 2008-08-24 12:03, Jérémy Bobbio wrote:
On Sat, Aug 23, 2008 at 04:48:05PM +0300, root wrote:
I installed Debian lenny successfully using the beta2 installer.
However the installer didn't support raid10, and I already created
a raid10 array (using Debian sid from an old HDD), and a raid1 array.
I installed on the raid1, and then copied /usr, /var over to the raid10 after
rebooting.
It would have been much easier, if the installer would have supported raid10!
The current development version (daily builds) of the debian-installer
support RAID 10. It should automatically detect your previous RAID 10
partitions when starting the partitioner.
Could you give it a try? You don't actually have to proceed further
than the main partioning screen.
I'll try it and report back (probably before thursday).
Best regards,
--Edwin
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
