Hello, I just tried to install bookworm on a Cubox-i.
What I did Downloaded firmware.MX6_Cubox-i.img.gz and partition.img.gz from: http://ftp2.de.debian.org/debian/dists/bookworm/main/installer-armhf/current/ images/netboot/SD-card-images/ Created and installation image: # zcat firmware.MX6_Cubox-i.img.gz partition.img.gz > /dev/sdc # sync Booted the device with a serial console attached: First issue I run into: No kernel modules were found. This probably is due to a mismatch │ │ between the kernel used by this version of the installer and the │ │ kernel version available in the archive. │ │ │ │ You should make sure that your installation image is up-to-date, or - │ │ if that's the case - try a different mirror, preferably │ │ deb.debian.org. │ │ │ │ The installation will probably fail to work if you continue without │ │ kernel modules. │ │ │ │ Continue the install without loading kernel modules? Are installation media and archive out of sync? Is there a nightly installation media I should try? I continued and then run into (might be a consequence from the first issue): ┌────────────────────┤ [!] Detect disks ├────────────────────┐ │ │ │ No partitionable media │ │ No partitionable media were found. │ │ │ │ Please check that a hard disk is attached to this machine. │ │ │ │ <Go Back> <Continue> Any feedback is welcome :-) Thanks Rainer -- Rainer Dorsch http://bokomoko.de/
