On Wed, 7 Nov 2012, Hoshpak wrote: > After rebooting the device, I am now able to log into the device using > ssh and start the installer. The only problem is, after a few minutes > the device resets itself thus aborting the installation process. This > happens no matter if the installer is actually doing something or just > waiting for input. Since the ssh-session is killed instantly when it > happens, I couldn't find out what caused the device to reset itself. > > This only happens when the Debian installer is loaded (I tried stable > and testing so far) and not with the original firmware so I believe the > device itself is just fine. Did anyone else experience this strange > behaviour with this Qnap system or could think of possible reason or an > alternative way to get the installation done?
Had sth similar when installing debian on an nslu2. Was a slowly dying power-supply. -- To UNSUBSCRIBE, email to debian-arm-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/alpine.LFD.2.00.1211081624170.27633@much-magic
