On Mon, Oct 25, 2010 at 11:23 AM, peter green <peter.gr...@postgrad.manchester.ac.uk> wrote: > On 25/10/2010 16:55, Robert Nelson wrote: >>>> >>>> That one is a pretty old development kernel, does my stable kernel do >>>> the same thing? >>>> >>>> http://rcn-ee.net/deb/lenny/v2.6.35.7-x6/ >>>> >>>> Install script: >>>> http://rcn-ee.net/deb/lenny/v2.6.35.7-x6/install-me.sh >>> >>> Ok with that kernel and buddy=zippy the beagleboard boots and the rtc on >>> the >>> beaglebuddy now works (though I had to manually reconfigure the init >>> scripts >>> to use it) >> >> Cool, good to hear that's working.. >> >>> The ethernet still doesn't seem to work though. >>> >>> [ 20.766082] enc28j60 spi4.0: enc28j60 Ethernet driver 1.01 loaded >>> [ 20.858734] enc28j60 spi4.0: enc28j60 chip not found >>> [ 20.906494] enc28j60: probe of spi4.0 failed with error -5 >>> >>> Any thoughts on what the problem could be? >> >> Are you 100% sure it's a zippy with the Microchip enc28j60? > > About as sure as I can be, there is a green sticker covering most of the > part number on the Ethernet chip (I could remove this but i'm not sure if > doing so would void any gaurantees so i'd rather not) on the Ethernet chip > but the bit of the part number I can see is "enc" and the pin count are > consistent with an ENC28J60. > > Looking at the photos of the zippy2 the ethernet chip on it looks very > different
Yeah, sounds like a zippy original... I uploaded the zippy setup routines for the beagle here http://pastebin.com/gJ194yDN line 146. I've only tested the zippy2 routines, of which were based off the zippy routines and came from/tested with angstrom.. Just as a test, does the angstrom uImage and modules work on your board with this module? http://www.angstrom-distribution.org/demo/beagleboard/uImage-2.6.32-r90+gitra6bad4464f985fdd3bed72e1b82dcbfc004d7869-beagleboard.bin http://www.angstrom-distribution.org/demo/beagleboard/modules-2.6.32-r90+gitra6bad4464f985fdd3bed72e1b82dcbfc004d7869-beagleboard.tgz Regards, -- Robert Nelson http://www.rcn-ee.com/ -- To UNSUBSCRIBE, email to debian-arm-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/aanlkti=h0+r2lefb6kyskv9ryopff=yjt1rcsagix...@mail.gmail.com
