Yes i can mount them from shell but the menu tiem "detect disks" fails
with "No disk drive was detected". I tryed it again from menu but it
fails always.
Attached the syslog captured from a second ssh session.
Steve
Martin Michlmayr schrieb:
* Steve Wagner <[EMAIL PROTECTED]> [2008-08-10 13:35]:
Hi, after getting to access my slug, ive got the next problem. The
installer dosnt find my drives. I have a 1GB USB Stick connected and a
320GB USB hard drive. As described in the manual
(http://www.cyrius.com/debian/nslu2/install.html) i loaded the
partman-ext3 and usb-storage modules. Because this dos not work ive tryed
also to load the other ATA modules. But they dosnt work too.
If i go to shell, i could mount both drives.
You can see the drives in the shell but the partitioner doesn't? Did
you try to restart the partitioner?
Can you end /var/log/syslog and /var/log/p* from the install?
Log file truncated to save memory.
Aug 10 12:19:56 init: init: process '/usr/bin/tail -f /var/log/syslog' (pid
768) exited. Scheduling it for restart.
Aug 10 12:19:56 init: init: starting pid 3258, tty '/dev/tty4': '/usr/bin/tail'
Aug 10 12:19:56 main-menu[1825]: DEBUG: resolver (libgcc1): package doesn't
exist (ignored)
Aug 10 12:19:56 main-menu[1825]: DEBUG: resolver (libparted1.7-udeb): package
doesn't exist (ignored)
Aug 10 12:19:57 main-menu[1825]: INFO: Falling back to the package description
for auto-install
Aug 10 12:19:57 main-menu[1825]: INFO: Falling back to the package description
for ai-choosers
Aug 10 12:19:57 main-menu[1825]: INFO: Menu item 'clock-setup' selected
Aug 10 12:19:57 kernel: warning: process `rdate' used the deprecated sysctl
system call with 1.40.
Aug 10 12:20:11 clock-setup: Sun Aug 10 12:20:11 UTC 2008 rdate: adjust local
clock by 14.199532 seconds
Aug 10 12:20:12 main-menu[1825]: DEBUG: resolver (libgcc1): package doesn't
exist (ignored)
Aug 10 12:20:12 main-menu[1825]: DEBUG: resolver (libparted1.7-udeb): package
doesn't exist (ignored)
Aug 10 12:20:12 main-menu[1825]: INFO: Falling back to the package description
for auto-install
Aug 10 12:20:12 main-menu[1825]: INFO: Falling back to the package description
for ai-choosers
Aug 10 12:20:12 main-menu[1825]: INFO: Menu item 'disk-detect' selected
Aug 10 12:20:15 net/hw-detect.hotplug: Detected hotpluggable network interface
eth0
Aug 10 12:20:15 net/hw-detect.hotplug: Detected hotpluggable network interface
lo
Aug 10 12:20:17 kernel: SCSI subsystem initialized
Aug 10 12:20:17 kernel: Initializing USB Mass Storage driver...
Aug 10 12:20:17 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Aug 10 12:20:17 kernel: usb-storage: device found at 2
Aug 10 12:20:17 kernel: usb-storage: waiting for device to settle before
scanning
Aug 10 12:20:17 kernel: scsi1 : SCSI emulation for USB Mass Storage devices
Aug 10 12:20:17 kernel: usbcore: registered new interface driver usb-storage
Aug 10 12:20:17 kernel: USB Mass Storage support registered.
Aug 10 12:20:17 kernel: usb-storage: device found at 3
Aug 10 12:20:17 kernel: usb-storage: waiting for device to settle before
scanning
Aug 10 12:20:22 kernel: usb-storage: device scan complete
Aug 10 12:20:22 kernel: scsi 0:0:0:0: Direct-Access USB FLASH
DRIVE PMAP PQ: 0 ANSI: 0 CCS
Aug 10 12:20:22 kernel: usb-storage: device scan complete
Aug 10 12:20:22 kernel: scsi 1:0:0:0: Direct-Access WD 3200JB
External 0107 PQ: 0 ANSI: 0
Aug 10 12:20:23 net/hw-detect.hotplug: Detected hotpluggable network interface
eth0
Aug 10 12:20:23 net/hw-detect.hotplug: Detected hotpluggable network interface
lo
Aug 10 12:20:25 kernel: Driver 'sd' needs updating - please use bus_type methods
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] 2015232 512-byte hardware sectors
(1032 MB)
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Write Protect is off
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Assuming drive cache: write through
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] 2015232 512-byte hardware sectors
(1032 MB)
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Write Protect is off
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Assuming drive cache: write through
Aug 10 12:20:25 kernel: sda:
Aug 10 12:20:25 kernel: sda1 sda2
Aug 10 12:20:25 kernel: sd 0:0:0:0: [sda] Attached SCSI removable disk
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] 625142448 512-byte hardware sectors
(320073 MB)
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Write Protect is off
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Mode Sense: 03 00 00 00
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Assuming drive cache: write through
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] 625142448 512-byte hardware sectors
(320073 MB)
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Write Protect is off
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Mode Sense: 03 00 00 00
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Assuming drive cache: write through
Aug 10 12:20:25 kernel: sdb:
Aug 10 12:20:25 kernel: sdb4
Aug 10 12:20:25 kernel: sd 1:0:0:0: [sdb] Attached SCSI disk
Aug 10 12:20:36 sshd[4292]: WARNING: /etc/ssh/moduli does not exist, using
fixed modulus
Aug 10 12:20:41 sshd[4292]: reverse mapping checking getaddrinfo for xxxx
[xxx.xxx.xx.xxx] failed - POSSIBLE BREAK-IN ATTEMPT!
Aug 10 12:20:43 sshd[4292]: Accepted password for installer from
xxx.xxx.xxx.xxx port 50397 ssh2
Aug 10 12:20:44 sshd[4295]: lastlog_filetype: Couldn't stat /var/log/lastlog:
No such file or directory
Aug 10 12:20:44 sshd[4295]: lastlog_openseek: /var/log/lastlog is not a file or
directory!
Aug 10 12:20:44 sshd[4295]: lastlog_filetype: Couldn't stat /var/log/lastlog:
No such file or directory
Aug 10 12:20:44 sshd[4295]: lastlog_openseek: /var/log/lastlog is not a file or
directory!
Aug 10 12:20:44 debconf: Setting debconf/language to en
