Hello,
Here is a small report in attachement, done with 2.6.11-rc4.
------------------------------------------------------------------------
* Hardware is nforce3 250GB, booting debian pure64 on pata (Maxtor 30Gb 6E030L0) drive. The goal is to mount data found on a sata disk (seagate 200Gb ST3200822AS). The pata drive holds / and lvm partition with /usr, /var /tmp and /home. The ultimate goal is to switch all this to the sata drive, which already holds a (barely used) swap partition.
* Soon after boot the console displays: nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device removed ... nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device removed nv_sata: Primary device added nv_sata: Primary device added and the sata disk seems to spin down at the same time. This is currently on 2.6.11-rc4, although I got the same behaviour with 2.6.10 and 2.6.11-rc3. Removing power from the drive and pluging it again seems to make te drive work some time , until it spins down again...
Seems like the hotplug code is triggering. That signals to me there is some connection problem. Maybe you have a bad cable, or maybe the cable is just seated improperly in one of the two SATA plugs.
It's also possible your motherboard or drive SATA plug is faulty, but I would replace the cable first.
Jeff
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
