Hi Samuel Samuel Thibault schrieb am 18.04.2022, 19:06 +0200: >Sebastian Humenda, le lun. 18 avril 2022 18:46:24 +0200, a ecrit: >> Samuel Thibault schrieb am 18.04.2022, 18:18 +0200: >> >> >Uh, perhaps there is a low-level communication problem, was that through >> >> >USB or Ethernet? >> >> >> >> It is connected via USB. >> > >> >I had had issues with USB connectivity on the Everest V3/V4 of our >> >university, we even had to replace the communication card. I'd recommend >> >trying with ethernet. >> >> Are you saying it is a hardware issue or are you hinting at a software issue >> on >> GNU/Linux? > >I'm not sure, I hadn't investigated. But at the very least it seemed >there were problems at the USB protocol itself, possibly Linux-specific >just unseen on Windows.
Ok, I see. For the sake of completeness, I have upgraded liblouis and am now seeing the same behaviour as with graphics embossing. The last page is half-emitted, stuck in the middle and the embosser stops responding. For the sake of completeness, I have attached an excerpt of the error log below. >> Using ethernet is not an alternative, as we have extremely restricted >> networking policies, with multiple layers of proxies. > >You could plug the embosser directly to a network board, without >exposing it to the network. That requires additional hardware because the ethernet port is already in use. Thanks Sebastian
