Michael Schmitz píše v Čt 29. 11. 2007 v 22:23 +0100: > > > think has since been solved is that I was unable to remote display > > > aranym. It wanted to do many screen refreshes a second which the > > > network was unhappy about. > > > > Mark, this is perfectly configurable... Set it to 1 FPS and your network > > should be 25 times happier than with the default setting :-) > > > > SETUP -> VIDEO -> Videl Refresh rate.
> Have you checked that this is in fact being honored by the Linux > framebuffer driver? In video=keep mode it should be, but otherwise Linux > might reprogram the VIDEL "registers" at boot. ARAnyM VIDEL emulation ignores refresh rate programmed in VIDEL HW registers. > Re: debug=par use for capturing installer logs: we can write a kernel char > device module that does just relay its input to the natfeat parport. I'll > see what I can come up with there... You don't need any natfeat parport driver - ARAnyM emulates the Atari parallel port hardware correctly (tested with PARCP). If linux-m68k can write to Atari parallel port then it will work in ARAnyM and you can choose where (on the host) to direct the output to - whether host's parallel port directly or a plain file. Petr -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]