dt crashed on me a couple of times while creating many line masks but none
of the masks were lost and I was able to continue until all 34 were
complete. It happened while creating the masks but not afterwards when I
was doing other things and the exports went fine. However, there may also
be a limit to these too. The crash is likely related to having 4gb
non-upgradeable RAM on the small laptop I take to the cottage so I wouldn't
worry about that.


On Thu, Aug 29, 2019 at 2:29 AM Jean-Luc Coulon (f5ibh) <
jean.luc.cou...@gmail.com> wrote:

> Hi,
> I also experienced this.
> The workaround is to open a second instance of the module.
>
> Regards
>
> Jean-Luc
>
> Le jeu. 29 août 2019 à 06:44, August Schwerdfeger <
> aug...@schwerdfeger.name> a écrit :
>
>> Recently when editing a dusty film scan I tried to use the "spot removal"
>> module to take care of the dust. After adding 64 strokes, I discovered that
>> any further strokes were no-ops, producing no visible change to the image
>> when added. I then created a second instance of the module; strokes added
>> there worked as expected.
>>
>> Is there an implicit limit of 64 strokes in the "spot removal" module?
>>
>> --
>> August Schwerdfeger
>> aug...@schwerdfeger.name
>>
>> ___________________________________________________________________________
>> darktable developer mailing list to unsubscribe send a mail to
>> darktable-dev+unsubscr...@lists.darktable.org
>>
>
> ___________________________________________________________________________
> darktable developer mailing list to unsubscribe send a mail to
> darktable-dev+unsubscr...@lists.darktable.org
>

___________________________________________________________________________
darktable developer mailing list
to unsubscribe send a mail to darktable-dev+unsubscr...@lists.darktable.org

Reply via email to