September 18, 2005
I have completed the installation of Cygwin from your website successfully and
would like to use it now.
The instructions I was given to start a session are:
1. Start Cygwin
2. In the black window that comes up enter: xwin
3. Start->Cygwin->xterm
4. In the xterm that comes up enter the following sequence of commands:
a. $ xhost +
b. $ telnet mind-d2
c. $ DISPLAY=theNameOfYourPC:0.0 ; export DISPLAY
d. $ kde
However, for Step #2 above when I enter "xwin", the response I get is:
bash: xwin: command not found
The operating system I have installed Cygwin on is Windows 2000 Service Pack 4.
Please advise as to how I should proceed.
I have checked the Cygwin User's Guide, but it does not seem to address
invocation errors. Is there another document I should refer to?
Thank you!
Elaine Baum
[EMAIL PROTECTED]
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://cygwin.com/docs.html
FAQ: http://cygwin.com/faq/
