I am experiencing the same delay with findutils 4.2.10-5. If I downgrade
to an older version of findutils, the delay goes away. On my system,
`find' was taking 30-40 seconds to start. I found that after I removed a
bad mapped network drive, the delay dropped to 6-7 seconds for `find' to
start. I am also finding that running `mount' to display the list of
mounts pauses for the same 6-7 seconds, and if I run `mount' and `find'
at the same time, they both always finish at the same time, even if I
start running them a couple seconds apart. That is about the extent of
diagnostic I have time to do right now.
IF
Andrew Stebakov wrote:
Hi,
I just updated my cygwin to latest (version 1.59) and
cygwin1.dll is 1.5.12.
I found that “find” command takes a long time to start
(about 20 seconds). It shows in my xemacs when I load
ecb and issue igrep-find.
I replaced the cygwin1.dll with some old version and
the problem went away (also I had to replace xargs,
grep and find executables for the old ones).
On another PC the same cygwin with xemacs doesn’t show
the problem.
Both of them have the VirusScan on. I tried to disable
the VirusScan but it doesn’t fix the problem.
What can I do fix it? Can I get the previous version
of cygwin1.dll?
Thanks in advance,
Andrei
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://cygwin.com/docs.html
FAQ: http://cygwin.com/faq/
