On 05/02/2014 09:06 AM, rob_hirschf...@dell.com wrote: > > Ok, it's been a long time since I've thought about that version. So > please accept my apologies in advance is my advice is fuzzy. > > > > I believe that you can set RAID to "none" in the Nodes...Bulk Edit > page. You may have to edit the "wall" in the Crowbar databag via Chef. >
So there is no options for "none" in the Bulk edit, only "[Not Set]". Sounds like it would be the same, though this is the value I had chosen for RAID in my earlier attempt but the result was still that my preferred RAID got replaced with RAID10 on a single disk. After the install the raid-configure role was assigned to the node eventhough I chose the not set option for deploy and removed the new node from the Default raid barclamp proposal (in an attempt to not have that role imprinted in steps after the deploy). > > > QUESTION: I did not think Betty included the open source RAID drivers > yet. You may have additional avenues for help than the open source list. > > > Correct, this version still has the closed-source components. I'm actually trying to not use any RAID configuration steps, which I think plants me in the open-source space. It's been my impression that not using the built-in proprietary raid configurations (RAID10 or JBOD) would be out-of-scope for this version of Crowbar. ~jpr > *From:*John-Paul Robinson [mailto:j...@uab.edu] > *Sent:* Friday, May 02, 2014 8:16 AM > *To:* Hirschfeld, Rob; crowbar > *Subject:* Re: [Crowbar] skipping raid config > > > > Version betty_openstack-build.2870.ubuntu-12.04 > > On 05/02/2014 07:53 AM, rob_hirschf...@dell.com > <mailto:rob_hirschf...@dell.com> wrote: > > Which version of Crowbar are you using? > > > > >
_______________________________________________ Crowbar mailing list Crowbar@dell.com https://lists.us.dell.com/mailman/listinfo/crowbar For more information: http://crowbar.github.com/
