Brian, Before doing that have you tried cleaning the outlet of any potential debris or blockage? Mine did the same thing before I launched this year and I managed to clear it out with a wire after a few jabs then it worked fine.
Regards Trevor On Wed, Jun 7, 2023, 5:00 p.m. Brian Morrison via CnC-List < cnc-list@cnc-list.com> wrote: > Hello Mates, > > Can anyone tell me the specific type of hose used for the intake on a > bilge pump? The pump in my CnC34 stopped pumping out. I checked the suction > on the pump by temporarily disconnecting the existing hose and attaching a > temporary. I put it in a bucket of water and the pump worked fine. I > followed the hose in the bilge as far back as I could see but cannot see > where it goes under the floor through the companionway. I’m not sure if it > is actually two hoses that connect and the connection has come loose or if > it’s one long hose that has been compromised. I plan to just run another > hose. Any suggestions on the best hose to use? > > Thanks > Brian C. Morrison > Please show your appreciation for this list and the Photo Album site and > help me pay the associated bills. Make a contribution at: > https://www.paypal.me/stumurray > Thanks for your help. > Stu
Please show your appreciation for this list and the Photo Album site and help me pay the associated bills. Make a contribution at: https://www.paypal.me/stumurray Thanks for your help. Stu
