Issue solved. Turns out when I updated the chart plotter, it disabled that instrument. I turned them back on and all is good.
Something to keep in mind when doing updates. Bob > On 04/26/2022 10:41 AM Joel Aronson via CnC-List <cnc-list@cnc-list.com> > wrote: > > > The transducer is made by Airmar in New Hampshire. Airmar is owned by > Gemeco. You might contact their tech support. I've had the temp fail on > that model, but not all 3. the warranty is 2 years from manufacture, not > install. Sorry! > > On Tue, Apr 26, 2022 at 10:37 AM ALAN BERGEN via CnC-List > <cnc-list@cnc-list.com mailto:cnc-list@cnc-list.com > wrote: > > > > It could be the transducer, or it could be the display. > If you know someone with B&G instruments, remove your display and connect it > to the other person's instruments. If it still doesn't work, it's the > display. if it does, it's the transducer. Usually when the transducer paddle > wheel isn't clean, the display shows 000, not ---. The transducer isn't > repairable. Check Amazon or eBay for a replacement. > > > > Alan Bergen > > 35 Mk III Thirsty > > Rose City YC > > Portland, OR > > > > > > > > On Tue, Apr 26, 2022 at 4:34 AM Bob Mann via CnC-List > > <cnc-list@cnc-list.com mailto:cnc-list@cnc-list.com > wrote: > > > > > > > My speed/depth/temp thru-hull is now showing > > dashes instead of values. It's the airmar DST800 that came with my B&G > > displays. Can these be repaired or am I SOL? Is there a number/email for > > B&G? The local, official installer isn't worth crap so even though only > > ~25 months old probably not covered under warranty. > > > > > > Bob > > > Mystic > > > > > > > > > > > > > -- > Joel > >
