Listers:
I have a question for you engineer types. I recently
noticed a nick in one of my rod rigging shrouds. I don't know much about
rod rigging failure considerations, but I do recall reading awhile back that
nicks are bad. Is there anything that can be done (short of replacement) to
address a nick to make a failure less likely?
As always, thanks in advance.
Matt
C&C 42 Custom
Matthew L. Wolford
638 West Sixth Street
Erie, PA 16507
(814) 459-9600 (Office)
(814) 459-9661 (Fax)
(814) 392-5599 (Cell)
The information contained in this e-mail note and any attachments is
intended for the personal and confidential use of the designated
recipient(s). This communication may be an attorney-client communication,
attorney work product, or otherwise privileged, confidential, or protected
from disclosure under applicable law. If you are not the intended recipient
or an authorized agent, you are hereby notified that you have received this
communication in error, and that any review, dissemination, distribution,
copying of, use of, or reliance upon this communication is prohibited. If
you believe this communication was sent to you in error, do not read it.
Please reply to the sender that you received the note in error and delete
it. Thank you.
Please consider the environment before printing this note.
Thanks to all of the subscribers that contributed to the list to help with the
costs involved. If you want to show your support to the list - use PayPal to
send contribution -- https://www.paypal.me/stumurray Thanks - Stu
