There is a calibration you can do if it's consistently off.  Sudden drops
to zero sounds more like an intermittent connection.  Differences of 0.1
knots seem likely just a rounding/truncation difference between displays.

On Sun, Aug 23, 2020 at 12:35 PM David Risch via CnC-List <
cnc-list@cnc-list.com> wrote:

> It under reports by a knot consistently at times.  Goes to zero
> indiscriminately.   Comes back and seems fine. Cycle again.  And again.
> Seemingly random pattern.   Paddle clean as a whistle.
>
> Oh...and ST60 speed repeater reads slight different speeds
> simultaneously...off by a 10th or two randomly.
>
> Thoughts?  Thanks in advance.
>
> Sent from my Android. Please forgive typos. Thank you.
>
> _______________________________________________
>
> Thanks everyone for supporting this list with your contributions.  Each
> and every one is greatly appreciated.  If you want to support the list -
> use PayPal to send contribution --   https://www.paypal.me/stumurray
>
>
_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray

Reply via email to