Hi Pete,

Plastic welding is the way to go.  I tried various ways to repair tanks, but my 
welded repairs (I fixed 3 tanks now by welding) have had no problems.  Plastic 
welding is rather easy to do.  The key is getting good plastic welding rods.   
I normally use a hot air welder, but if you are very careful, you can use make 
due with a propane torch.  Though I highly recommend borrowing or buying a 
welder.  Harbor Freight sells a reasonable welder for about $60, and since they 
always have 20-25% off coupons, it would cost about $45.

Small leaks are easy to fix.  If you have a more serious repair, like a long 
crack due to poor structural support, then repair and split it with some 316 
stainless mesh. 

I purchased a package of 1/8" LDPE welding rods from Grainger. As I recall, it 
was 50 rods for $15.   I also purchased 316 mesh from Grainger.

I have details on my blog. Below is the link.  Skip down to the section on 
plastic welding.

http://svjohannarose.blogspot.com/search/label/WaterTankRepair


-
Paul E.
1981 C&C Landfall 38 
S/V Johanna Rose
Fort Walton Beach, FL

http://svjohannarose.blogspot.com/

> On Sep 7, 2019, at 12:00 PM, cnc-list-requ...@cnc-list.com wrote:
> 
> Message: 2
> Date: Fri, 6 Sep 2019 22:31:13 +0000
> From: kelly petew <kellype...@msn.com <mailto:kellype...@msn.com>>
> To: "cnc-list@cnc-list.com <mailto:cnc-list@cnc-list.com>" 
> <cnc-list@cnc-list.com <mailto:cnc-list@cnc-list.com>>
> Subject: Stus-List Water Tank Woes [again] - Welding Question
> Message-ID:
>       
> <bn6pr07mb350617d6994a117c6619a6fdc1...@bn6pr07mb3506.namprd07.prod.outlook.com
>  
> <mailto:bn6pr07mb350617d6994a117c6619a6fdc1...@bn6pr07mb3506.namprd07.prod.outlook.com>>
>       
> Content-Type: text/plain; charset="us-ascii"
> 
> My water tank is leaking again. I want to attempt a weld to repair it.
> 
> It is a Kracor polypropylene tank, but the labeling details have faded over 
> time, and no longer legible.  I don't know what kind of polypropylene was 
> used to construct the tank.
> So, the question is, do I use hi-density OR lo-density polypropylene?  Or, 
> does it matter?
> 
> Thanks!
> 
> Pete W.
> Siren Song
> C&C 30-2
> Deltaville, Va.

_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray

Reply via email to