Listers:
While on the topic of unwanted water accumulation, I have a couple limber
holes that were not drilled level with the hull (about 1/2” too high) and, as a
result, a certain amount water must accumulate before the area drains. The
result is that these areas are always wet. I suppose I could open up the
limber holes, but they appear to be tubes glassed in place (metal or
fiberglass, which is painted). A prior owner placed bondo or something on the
hull to eliminate the gap below the limber hole but did not do a very good job.
I am thinking about replacing the bondo with another leveling material –
something that would pour in and harden instead of being troweled in and uneven.
Any thoughts?
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use PayPal
to send contribution -- https://www.paypal.me/stumurray
_______________________________________________
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use PayPal
to send contribution -- https://www.paypal.me/stumurray
