Hello all,
Below is the text from a post I made earlier this year regarding the caps for 
C&C water tanks:
After striking out at our local RV store and online searches, I called Kracor 
tanks.  They told me in no uncertain terms they only work with boat 
manufacturers, not individuals.  They tried to tell me to call C&C.  Finally I 
got connected with someone back in the shop who directed me to: 

Claires Marine Outfitters2921 SW 2nd Ave, 
Fort Lauderdale, FL 33315(954) 523-4301
They had them in stock, $10 apiece plus shipping.
You may want to make a note of this if you think you'll need a cap someday.
As it turns out the lip on one of my caps is bent up, and as a result the cap 
itself is leaking through a crack.  Thus the need for the replacement.  

By the way, I took the advice of getting x type o-rings, and for about $10 I 
got a package of 10.  They work great and seal much better than the original 
gasket/o-rings.  I got them through McMaster Carr.  

Thanks everyone for the help, 
 Bruce Whitmore
1994 C&C 37/40+"Astralis"
(847) 404-5092 (mobile)
bwhitm...@sbcglobal.net

      From: Wade Glew via CnC-List <cnc-list@cnc-list.com>
 To: cnc-list@cnc-list.com 
Cc: Wade Glew <wadeg...@gmail.com>
 Sent: Tuesday, June 19, 2018 1:50 PM
 Subject: Re: Stus-List C&C34 Water tank hatch covers
   
I had to replace these on a C&C 30 Mk II a few years ago. It was a 1986 but I 
believe C&C had the same tank manufacturer forever. The company name was 
embossed faintly on the screw on port caps which I then used to Google search 
and source new ones (which were very inexpensive by the way). If my memory 
serves me (less so anymore) the name was Krakor?  I can look on my boat this 
weekendWade33 Mk IIOh Boy
On Mon, Jun 18, 2018, 07:01 Nathan Post via CnC-List, <cnc-list@cnc-list.com> 
wrote:

The domestic fresh water tank (I assume original) on my 1981 C&C 34 has two 
ports in the top with screw in covers with 3.5" diameter threads.  The covers 
have degraded to the point that they no longer thread in (the plastic has 
shrunk - probably due to a chemical used by the previous owner or perhaps just 
time and heat.  The outer threads seem to be in good shape but I have been 
unable to find a replacement port cover of the same size.  Any suggestions on 
there on where to find these covers so I don't need to cut the whole thing out 
and install new plate assemblies?
NathanS/V Wisper1981 C&C 34
_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray


_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --  https://www.paypal.me/stumurray



   
_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray

Reply via email to