.....and once you insert and center them, make an indent on each side next to 
the chain plate with a metal chisel to keep them in place. 

Dennis C. 

Sent from my iPhone

> On Apr 25, 2018, at 2:16 PM, Bill Dakin via CnC-List <cnc-list@cnc-list.com> 
> wrote:
> 
> I would grab a micrometer to mic the diameter and match up with SS round 
> stock at a hardware store or elsewhere.  But you may not have one to measure. 
>  The pins are transition fit and require very mild persuasion to insert.
> 
>> On Wed, Apr 25, 2018 at 1:17 PM, Glen Eddie via CnC-List 
>> <cnc-list@cnc-list.com> wrote:
>> Hello everyone,
>> 
>>  
>> 
>> As one of the final steps in getting Freya IV back in the water, I need to 
>> buy/replace 3 of the pins that were on the aluminum cover over the chain 
>> plate on a C&C35 MkI.  Does anyone know if these are stock items and if in 
>> the 
>> 
>> 
>> 
> 
>  
> Bill Dakin
> S/V Tapestry
> 25-2
> _______________________________________________
> 
> Thanks everyone for supporting this list with your contributions.  Each and 
> every one is greatly appreciated.  If you want to support the list - use 
> PayPal to send contribution --   https://www.paypal.me/stumurray
> 
_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray

Reply via email to