The pedestal guard tends to move a lot where it contacts floor since many use it as a handhold and put torque on it. I would think Butyl due to this constant flexing would be an excellent idea
Mike Persistence From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Ron Ricci via CnC-List Sent: Tuesday, January 16, 2018 9:33 AM To: cnc-list@cnc-list.com Cc: Ron Ricci Subject: Re: Stus-List Stopping leaks through pedestal guard feet? Bruce, I had a similar problem with my pedestal guard and used butyl rubber. The pedestal guard with feet were moved up after loosening the set screws that hold it to the pedestal structure. This allowed butyl rubber to be placed around the threaded part of the feet. The pedestal guard was then pushed back down so the butyl rubber filled the penetrations in the deck. The pedestal guard feet are held against the deck. It worked. The cables run inside the pedestal guard and under the “bubble” located top/aft/centerline in the aft cabin headliner. Without removing the cables, I could not remove the pedestal guard. It looked like the bottom of the feet were threaded and designed to take a lock nut. If the above fix above did not work, I considered drilling holes in the “bubble” and adding lock nuts to hold the feet down.. Ron From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Bruce Whitmore via CnC-List Sent: Monday, January 15, 2018 4:50 PM To: C&C List Cc: Bruce Whitmore Subject: Stus-List Stopping leaks through pedestal guard feet? Hello all, We have a 1994 C&C 37/40+, and we are replacing the stern and v berth mattress foam and fabric. I have noticed a very small leak which is coming from the starboard pedestal guard foot, where the bolts and wires penetrate the cockpit floor. We have stopped the vast majority of the leak by applying a small layer of aluminum duct tape at the point where the stainless tubing penetrates the stainless foot. There is a hard plastic spacer that fills the gap between the tube & the foot, but it doesn't seem to be made of the proper material to be properly water resistant. So, I expect this leaves us with water coming in under the foot itself, where it is bolted through the floor of the cockpit itself (which is finished with teak). What would you suggest as to the best way to seal this? The leak we get is coming down over the stern berth, and I sure don't want leaks staining our new fabric! I am thinking about loosening the feet & lifting up the pedestal guard, and applying butyl rubber to the bottom. If that works, great. But, how would I also more permanently stop water ingress due to water finding its way between the tube and the foot? Thanks for your ideas! Bruce Whitmore Bruce Whitmore (847) 404-5092 (mobile) bwhitm...@sbcglobal.net<mailto:bwhitm...@sbcglobal.net>
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
