Adam,The VHB tape is only what holds the port light in place. It is the Dow 
Corning that does the actual sealing. I am experimenting with installing my new 
port lights, on my LF39, only during the cool part of the day and keeping the 
plexiglass out of the Sun as much as possible. On my last boat, LF38, I 
installed them during the hottest part of the day, and after some time I found 
a couple of leaks. These were where I had less than a 1/4 inch gap for sealant. 
My thinking on this is that the plexiglass expands when hot. I figure it is 
better to squeeze the sealant than have the plexiglass pull away when in 
shrinks when cool. I also rough up the edges and anywhere the sealant will be, 
along with minimum 1/4 inch gap. I am replacing both side port lights 6ft long 
by 8 inches tall, and 3 hatch lenses. FWIW. 

Sent from my T-Mobile 4G LTE DeviceDoug Mountjoy POYC Pegasus (for sale) Lf38 
Rebecca Leah  LF39 
-------- Original message --------From: Adam Hayden via CnC-List 
<cnc-list@cnc-list.com> Date: 8/13/17  05:53  (GMT-08:00) To: 
cnc-list@cnc-list.com Cc: Adam Hayden <hayden.a...@hotmail.com> Subject: 
Stus-List Port replacement 


Hey all.  I am finally going to replace the ports in my C&C 36.  I know this 
has been discussed at length.  Just quickly will the 3M vhb tape work and does 
it seal as well.





Thanks 





Adam Hayden






Get Outlook for Android



_______________________________________________

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to:  
https://www.paypal.me/stumurray

All Contributions are greatly appreciated!

Reply via email to