"Once the mast is out, how best to plug the whole in the deck?" 

What I did this offseason was crude and simple, but hopefully effective. I had 
a roll of thick plastic sheet laying around the garage, and a really big 
twist-tie thing made of rubber-coated wire. So I just cut an oval of the 
plastic big enough to cover the hole with a few inches of overhang all around, 
then cinched it up around the base of the collar with the big twist-tie thing. 
It's not going to blow off, and it's not going to leak water, and it's not 
going to sag in. 

Cheers, 
Randy 

----- Original Message -----

From: "kelly petew via CnC-List" <[email protected]> 
To: "cnc-list" <[email protected]> 
Cc: "kelly petew" <[email protected]> 
Sent: Thursday, December 8, 2016 8:56:46 AM 
Subject: Stus-List Looking for Tips on ROD Re-Rigging Process 



Hello Listers, 




My 30-2 is 25+ years young. I've been the owner since 2003, and I am reasonably 
sure the standing, rog rigging is original. 

I've met with a rigger and I am awaiting his recommendation ,including the 
costs and other options. I'm hoping the existing rod [25 years old] can be 
re-headed as this would be the less costly route to go[not counting "doing 
nothing", of course]. 



I'm in the yard and they can pull the mast as early as next week. 




That said, I would appreciate any tips on this project. For example, once the 
mast is out, How best to plug the hole in the deck? 

Also, while the mast is down, I want to replace the VHF cabling, install LED 
lights, clean/paint the mast. 

Any suggestions in these areas would be great!!! 




Fair Winds, 




Pete W. 

Siren Song 

'91 C&C30-2 

Deltavillle, Va. 



_______________________________________________ 

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to: 
https://www.paypal.me/stumurray 

All Contributions are greatly appreciated! 

_______________________________________________

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to:  
https://www.paypal.me/stumurray

All Contributions are greatly appreciated!

Reply via email to