My boat came with a teak and holly sole . It was actually a pine I think with dark strips as apposed to the dark teak strips . The galley was cut into pieces . There were spacers over the bilge to make it level. I custom cut the VEE berth. Not as good a job as Eric but it will do . I was lucky to have the old floor to use as a pattern . My floor was screwed down . The only issue I had was by my ice box . The screw hole was right where the cabin sole meet the hull and I drilled right through my hull . Oops . It's all good now. Lessons learned .
Sent from Joe Bognar > On Mar 19, 2016, at 9:52 AM, Stu via CnC-List <cnc-list@cnc-list.com> wrote: > > Eric Dinn has provided a very good sequence of photos of his teak and holly > floor installation. > > The installation was done on Arbutus, a 1974 C&C 30 MK I, out of Comox, BC, > Canada. > > It’s on the Photo Album at: > http://www.cncphotoalbum.com/doityourself/teak_holly_floor/ > > Stu > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the bottom > of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
