If I am understanding you correctly, I would think you could bore those holes slightly oversize, and squeeze in either a stainless tube bushing, or Nylon of Delrin bushing, which would make a much nicer bearing surface.
Bill Coleman C&C 39 Erie, PA -----Original Message----- From: CnC-List [mailto:[email protected]] On Behalf Of Alan Liles via CnC-List Sent: Saturday, March 12, 2016 12:22 PM To: Stuslist Cc: Alan Liles Subject: Stus-List Gooseneck fitting Preparing to remove my rig, I found the gooseneck fitting (toggle?) worn around the vertical pin. Where might I source a new one. The boat is a '94 37/40+. I'm not sure of the manufacturer. On another note, is there a way to search subjects in the list archive? I'm sure this has come up before but I haven't found a way to retrieve the thread. Cheers, Al _______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
