I noticed that the grounding wires in the bilge have been cut (since I inherited Cat’s Paw in 2005!) so they are not connected to the keel bolts. I can splice wires onto the cut ends to reach the bolts, but what is recommended as terminals to connect the wires to the bolts? It would be helpful if this did not involve unscrewing the big nuts on the bolts, but perhaps some terminals that connect to the top of the bolts?
Eric Frank Cat's Paw C&C 35 Mk II Mattapoisett, MA
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
