I would recommend Masonite (tempered hardboard) for this job. It is
available in 1/8 or 1/4 inch thicknesses.
Bill Bina
On 1/26/2016 12:08 PM, Adam Hayden via CnC-List wrote:
Hi Steve.
My panels on my C & C 36 have been replaced. The originals were 1/8 of an
inch plywood(although it looks more like wood paneling type material) covered with
a vinyl/ foam pad. I was fortunate to have my existing panels as a template. I
used 1/8 plywood and went to a fabric store and purchased a few yards of marine
fabric/vinyl. a spray adhesive to attach the fabric to the new panel. The
original panel had little plastic caps that fit over the screws which I was able to
recycle and use again.
I would think 1/4 inch wood would be a little more difficult to bend to the
curve of the top of the liner.
Good luck with the project.
Adam Hayden
State of Bliss
C&C 36
Sent from my iPhone
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
