I am not sure I understand what you are doing. How do you support the anchor/chain while you get forward to get a gaff hooked onto it? Dave
On Aug 17, 2015, at 8:46 AM, Bill Hoyne via CnC-List <cnc-list@cnc-list.com> wrote: > I have a Rocna 20kg anchor and although I have a windlass I don't use it to > pull the anchor over the roller. I use a gaff over the pulpit to hook on the > roller of the anchor. Pull it home with no problem and can hold in place > while I tighten it up. Works like a charm and a lot less stress on the > equipment. > Bill > Mithrandir > C&C 35 MKII > > > Sent from my iPhone > > On Aug 17, 2015, at 7:17 AM, David Knecht via CnC-List > <cnc-list@cnc-list.com> wrote: > >> And now for something completely different- I have only used my anchor a few >> times, but I have found it really hard to recover by hand- much harder than >> the one I had on my C&C34. The anchor is heavier- Rocna 27 lb, and the >> chain is heavier. I can pull it up by hand, but when it gets to the roller, >> there is no way to get the long stem of the anchor around the 90° turn of >> the roller. I am usually sitting in the anchor well with my feet braced to >> pull the chain up. At that point, I have to stand up and grab the chain so >> I can pull vertically to get the stem over the roller. There must be an >> easier way (other than a electric windlass). Does anyone have any tricks? >> Dave >> >> Aries >> 1990 C&C 34+ >> New London, CT >> >> <pastedGraphic.tiff> >> >> _______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> To change your list preferences, including unsubscribing -- go to the bottom >> of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the bottom > of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > Dr. David Knecht Professor of Molecular and Cell Biology Core Microscopy Facility Director University of Connecticut 91 N. Eagleville Rd. Storrs, CT 06269 860-486-2200
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
