My Harken 01 uses 5/16" line and a figure eight knot works fine to keep the line in the drum.
Found the manual online and if it is the same model, a knot would work for you too. http://www.harken.com/uploadedfiles/Product_Support/PDF/mk3-0-4862.pdf Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md ----- Original Message ----- From: "Marek Dziedzic via CnC-List" <cnc-list@cnc-list.com> To: cnc-list@cnc-list.com Cc: "Marek Dziedzic" <dziedzi...@hotmail.com> Sent: Wednesday, July 22, 2015 10:06:48 AM Subject: Stus-List replacing furling line I need to replace the furling line in my Harken Unit 00 furler. I have the manual, but the instructions are very vague. I would appreciate any hints, if anyone of you have done this before. One more thing: the instruction call for securing the line with a “hog ring”. Is there an easy way of doing it? I am not about to buy a special tool and a load of 1000 fasteners to use just one. thanks for your help Marek C270, “Legato” in Ottawa _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
