You can buy just a depth unit but suspect the bigger challenge will be shape. Most 1980 vintage instruments were round. Most of what is produced today is square. Tons of cosmetic solutions but know you're in for a bit of a project. Also, the transducer will likely need to be changed.
Good luck! John Sent from my iPad > On Jun 14, 2015, at 4:08 PM, McElwreath, Daniel via CnC-List > <cnc-list@cnc-list.com> wrote: > > The readout on my cockpit depth display on 1980 cnc 32 is barely readable in > the daylight. I have been unable to find a source for simply replacing the > displau unit. Can that be done? or do I have to buy a complete set, with > transducer, etc. Thanks for any guidance. Dan Mc on Tively II at City Island > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the bottom > of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
