When I recently dropped my rudder I found the retaining ring needed
serious encouragement to come off, had to put a pipe wrench to it. The
strap wrench did not do it at all.
Hope yours is more free than that. Apply lubrication liberally!
Graham Collins
Secret Plans
C&C 35-III #11
On 2014-10-24 1:56 PM, Joel Aronson via CnC-List wrote:
All,
My new Delrin bearing for the top of the rudder post is ready.
The boat is staying in the water. Do I need run a line under the
rudder to the stern cleats before I loosen the retaining ring? Or
should I put a shim under the quadrant to limit the drop?
Do I need anything besides allen wrenches and a strap wrench?
As always, thanks for the advice!
--
Joel
35/3
The Office
Annapolis
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
