Hi Steve....I mounted the ST60 (?) controller on an Edison arm and pod off of the binnacle hand hold. The 'brains' I mounted on the bulkhead at the nav station...remember that LF's have that bulkhead at the base of the companionway...and the fluxgate I mounted below the galley sink under the removable access port. An easy enough job and all went well. The Edson parts are not cheep, but, quite well made. It was a good choice as I do not have a 'pod'. Good Luck!
Spencer Johnson 1984 C&C LF 38 "Alegria" #165 ~~~_/) * ~~~~ Mount Prospect, IL ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Winks via CnC-List Sent: June 3, 2014 10:03 AM To: cnc-list@cnc-list.com Subject: Stus-List Raymarine X5 auto pilot installation C&C 34+ Hi. I am planning to install a Raymarine X5 wheel pilot in my C&C 34+. Does anyone have any advice on where best to install the computer and flux gate compass? Thanks for any help. Steve Winks Corsair VI 1990 C&C 34+ Midland, ON
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
