is this the mixing elbow everybody has? http://www.oldportmarine.com/misc_gm_ym_uelbow_assy.htm Gary ---- ahycr...@cox.net wrote: > are all you guys talking about the yanmar 3gm30f engine? > > > Gary Kolc > ---- Wally Bryant <w...@wbryant.com> wrote: > > Absolutely. I think that hours of heat on that hose/mixer elbow > > connection makes it impossible to remove without cutting it off. I keep > > a section of 2" exhaust hose stuck in the back of the boat, just in case > > I need to do it again. Maybe next time I'll try some Permatex #2 gasket > > sealant, which handles extended high temps without getting crusty. > > There's always something new to try and figure out. > > > > Wal > > > > John Russo wrote: > > > The hardest part was the short hose interfacing > > > the elbow with the muffler and I had a problem removing and reconnecting. > > > There doesn't appear to be any short cuts unless you are willing to cut > > > off > > > the interface hose and replace it with a new one. > > > > > > _______________________________________________ > > This List is provided by the C&C Photo Album > > http://www.cncphotoalbum.com > > CnC-List@cnc-list.com > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
