Can you install a plastic bulkhead fitting with a gasket even if you have to
enlarge the hole? If you install a threaded bulkhead fitting, you can adapt it
to whatever hose size you need. See:
http://www.mcmaster.com/#tank-fittings/=opwtlv
Dennis C.
Touche' 35-1 #83
Mandeville, LA
>________________________________
> From: kelly petew <kellype...@msn.com>
>To: cnc-list <cnc-list@cnc-list.com>
>Sent: Sunday, September 29, 2013 9:59 AM
>Subject: Stus-List Leaking H2O tank-how to remove failed adhesive
>
>
>
>
>My forward tank had [still has] a slow leak at its lowest point where the
>water line exists.
>
>I used a tube of adhesive [polyurethane, I think, but not sure] in an attempt
>to seal it. It appears the adhesive did not bond well with the tank
>[polypropylene]
>In any event, it's a botched job and I need to start over.
>Any suggestions on adhesive removal would be greatly appreciated. I suppose I
>could try and cut it away from the tank and line, but I fear I might puncture
>the tank. The tank is under V-berth, and I wouldn't want to have to remove
>it!!
>
>Also, has anyone had any success using Captain Tolley's creeping crack cure on
>this sort of repair??
>
>
>Fair Winds,
>
>Pete W.
>
>C&C30MKII
>Deltaville, VA
>
>_______________________________________________
>This List is provided by the C&C Photo Album
>http://www.cncphotoalbum.com
>CnC-List@cnc-list.com
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
