Just type ping at the command line with no options to find out. Look for the
following:
[-I interface or address]
Cheers,
Quoting Cade Cairns <[EMAIL PROTECTED]>:
Like I said, some versions of ping might allow you to specify the
source interface (or address) as yours apparently does. However, they
don't all do that.
On Thu, 17 Feb 2005 14:14:47 -0700, Peter Van den Wildenbergh
<[EMAIL PROTECTED]> wrote:
Cade Cairns wrote:
>I am sure there are versions of ping that let you specify the source
>interface, but the first thing that comes to my mind is packit
>(http://packit.sourceforge.net/).
>
>On Thu, 17 Feb 2005 12:31:42 -0700, Kevin Anderson
><[EMAIL PROTECTED]> wrote:
>
>
>>If I have 2 ips on a nic, and I want the ping to originate from
the second,
>>eth0:1, how would I go about making that happen? Is it even possible.
>>
>>
I have this setup
eth0 = 10.10.11.1
eth0:1 = 10.100.5.1
ping commands I use
ping 10.10.12.2
PING 10.10.12.2 (10.10.12.2) from 10.10.11.1 : 56(84) bytes of data.
64 bytes from 10.10.12.2: icmp_seq=0 ttl=63 time=849 usec
and
ping -I 10.100.5.1 10.100.5.5
PING 10.100.5.5 (10.100.5.5) from 10.100.5.1 : 56(84) bytes of data.
64 bytes from 10.100.5.5: icmp_seq=0 ttl=128 time=605 usec
This helps?
(And does what I think it should do?)
Peter
--
Regards,
Cade Cairns
---------------------------------------------------
This message was sent using Echostar Secure Webmail
pgpYRL9tdO5mS.pgp
Description: PGP Digital Signature
binR4X6U7Jz6M.bin
Description: PGP Public Key
_______________________________________________
clug-talk mailing list
[email protected]
http://clug.ca/mailman/listinfo/clug-talk_clug.ca
Mailing List Guidelines (http://clug.ca/ml_guidelines.php)
**Please remove these lines when replying
