Török Edwin wrote:
On 2009-12-19 00:56, Jim Preston wrote:
Could freshclam be causing it to crash? I have a cron job set to run
freshclam at 10 minutes after each hour. In looking at the logs again
I just noticed that the crash all occur around 10 after the hour.
Dec 18 13:10:57 JimFedora sendmail[11696]: nBIKAmTr011696:
milter_sys_read(clamav-milter): cmd read returned 0, expecting 5
Dec 18 13:10:57 JimFedora sendmail[11696]: nBIKAmTr011696: Milter
(clamav-milter): to error state
Dec 18 14:10:57 JimFedora sendmail[13869]: nBILAmMO013869:
milter_sys_read(clamav-milter): cmd read returned 0, expecting 5
Dec 18 14:10:57 JimFedora sendmail[13869]: nBILAmMO013869: Milter
(clamav-milter): to error state
Dec 18 15:10:57 JimFedora sendmail[16083]: nBIMAmTC016083:
milter_sys_read(clamav-milter): cmd read returned 0, expecting 5
Dec 18 15:10:57 JimFedora sendmail[16083]: nBIMAmTC016083: Milter
(clamav-milter): to error state
Could I have a bad setting in the freshclam.conf?
Why should the milter be affected by freshclam? Its only purpose is to
interface between your MTA and clamd.
As long as clamd is up and running, the milter should not be influenced
by freshclam.
I agree and my last post states it is not related, just a coincidence
that it fails at the same time interval as the freshclam update. While
freshclam was stopped, clamav-milter continued to fail at 10 minutes
after the hour.
Thanks, Jim
_______________________________________________
Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net
http://www.clamav.net/support/ml
