I tried to upgrade my previous 0.94 installation and have issues with the new milter, although I went through the docs, eg. at http://lurker.clamav.net/message/20081205.152347.a7d7c9ee.en.html
I installed clamav-0.95-1.el4.rf.src.rpm , removed /etc/sysconfig/clamav-milter and modified my /etc/clamav-milter.conf. However, sendmail does not access the milter properly, no matter if I use local: or inet: mode. To avoid any permission issues, I use MilterSocket inet:7...@127.0.0.1 in my conf and access that port in my sendmail.mc via INPUT_MAIL_FILTER(`clamav', `S=inet:7...@127.0.0.1, F=, T=S:4m;R:4m')dnl - but the Eicar test string isn't detected, all messages pass. The port is open: telnet localhost 7357 Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. and sendmail complains immediately once I shutdown the milter, but no emails get scanned. clamd is up and running, both accessible via socket and on port 3310. I noticed the announcement that the "old" milter is included in the 0.95 tarball - are there any instructions how to compile that one ? A configure --enable-milter doesn't build the old milter, only the new one. Any help really appreciated... Regards, Steffan -- No part of this message can be made available on any web page, message board or newsgroup without the permission of the sender. _______________________________________________ Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net http://www.clamav.net/support/ml
