Dear All, I'll try uograde to 6.3 then install clamav 0.9.4 thank's for every body.
在 2008/9/23 下午 10:20 時， [EMAIL PROTECTED] 寫到： > Rob MacGregor wrote: >> On Tue, Sep 23, 2008 at 14:30, <[EMAIL PROTECTED]> wrote: >>> Or you can just delete --enable-gethostbyname_r from the >>> CONFIGURE_ARGS >>> section of the port Makefile and everything will work fine. I would >>> advise that you stick with 6.3 as it has a longer support cycle than >>> anything so far in the 7.x cycle. >> >> Right now the EOL for 6.3 is based upon it being the last 6.x. >> However, 6.4 is scheduled to be released next month, at which point >> the EOL for 6.3 will be 12 months from it's release - January 2009, a >> month before 7.0 (February 2009). Details of how the EOL process >> works can be found at http://www.freebsd.org/security/#sup >> > > Sorry but I don't see where it says that. I see this: > > "Please note that these dates may be extended into the > future, but only extenuating circumstances would lead > to a branch's support being dropped earlier than the > date listed." > > So unless some extenuating circumstances come along 6.3 > should be good until 1/31/2010. > > It also says this: > > Extended: Selected releases will be supported by the Security > Officer for a minimum of 24 months after the release. > > 6.3 is labeled as an "extended" release and it was released > 01/18/2008. > > If they don't stick to these dates they should not even bother > publishing them because they would be meaningless. > > Steven > _______________________________________________ > Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net > http://www.clamav.net/support/ml _______________________________________________ Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net http://www.clamav.net/support/ml
