Hi Nigel Citat Nigel Horne <[EMAIL PROTECTED]>:
> On Wednesday 05 May 2004 7:53 pm, S=F8ren Schimkat wrote: > > > When using the same config file at shown below .. and starting > > clamav-milter with these options: > > > > --force-scan --config-file=3D/opt/clamav-0.70/etc/clamav.conf > > --quarantine-dir =3D/var/quarantine /var/run/clamav/clmilter.sock > > > Could someone please tell me what to do, in order to just send mail to > > the sender, the reciepient and postmaster ... and to ensure that only > > one copy of the mail is quarantined. > > Try turning off the scanning of local e-mails (don't use the --force-scan= > option, > you may wish to add --local that's up to you). Thanks for the tip. I´m sorry to say that i´t didn´t work. What did work was using the --quiet option for not sending any mails at all. This prevented the looping. I'm going to the --quiet option in the future - so the problems is solved. Regards Søren > > > Regards S=F8ren Schimkat > > -Nigel > > --=20 > Nigel Horne. Arranger, Composer, Typesetter. > NJH Music, Barnsley, UK. ICQ#20252325 > [EMAIL PROTECTED] http://www.bandsman.co.uk > > > > ------------------------------------------------------- > This SF.Net email is sponsored by Sleepycat Software > Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to > deliver higher performing products faster, at low TCO. > http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3 > _______________________________________________ > Clamav-users mailing list > [EMAIL PROTECTED] > https://lists.sourceforge.net/lists/listinfo/clamav-users > ------------------------------------------------------- This SF.Net email is sponsored by Sleepycat Software Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver higher performing products faster, at low TCO. http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3 _______________________________________________ Clamav-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/clamav-users
