Please excuse me if this is a reviewed topic. I can't find similar posts on the lists.
I am using ClamAV 0.70 with clamav-milter 0.70j.
I can't stop clamav-milter with the term signal. (kill pid)
I must use the kill switch to end the process and after that remove by hand the sock created by clamav-milter to star the process again.
Could this be a load problem? I mean... it is possible that clamav-milter is to busy to stop?? or this is an other kind of problem?
Please excuse me again for the lack of info. I don't know how to debug this issue.
Many thanks,
with Best Regards! Matías.
-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3
_______________________________________________
Clamav-users mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/clamav-users
