Dear expert
we've an issue in setting up a port-channel between a Juniper EX4400 and a
Cisco Nexus N9K-C93180YC-EX over an SX 1 Gbs link.
We've implemented the following configuration but on Juniper side it is
interface flapping while on Cisco side it remains down.
Light levels seem ok.
Has anyone ever experienced the same ? Any suggestions ?
Thanks in advance for any hint
Kind regards
James
JUNIPER *****************************
> show configuration interfaces ae10 | display set
set interfaces ae10 description "to Cisco leaf"
set interfaces ae10 aggregated-ether-options lacp active
set interfaces ae10 aggregated-ether-options lacp periodic fast
set interfaces ae10 unit 0 family ethernet-switching interface-mode trunk
set interfaces ae10 unit 0 family ethernet-switching vlan members 301
> show configuration interfaces ge-0/2/3 | display set
set interfaces ge-0/2/3 description "to Cisco leaf"
set interfaces ge-0/2/3 ether-options 802.3ad ae10
> show vlans VLAN_301
Routing instance VLAN name Tag Interfaces
default-switch VLAN_301 301
ae10.0
CISCO *******************************
interface Ethernet1/41
description <[To EX4400]>
switchport
switchport mode trunk
switchport trunk allowed vlan 301
channel-group 41 mode active
no shutdown
interface port-channel41
description <[To EX4400]>
switchport
switchport mode trunk
switchport trunk allowed vlan 301
# sh vlan id 301
VLAN Name Status Ports
---- -------------------------------- ---------
-------------------------------
301 P2P_xxx active Po1, Po41, Eth1/1, Eth1/41
VLAN Type Vlan-mode
---- ----- ----------
301 enet CE
Remote SPAN VLAN
----------------
Disabled
Primary Secondary Type Ports
------- --------- ---------------
-------------------------------------------
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
