On 10/17/21 04:12, Tim Densmore wrote:
Hi Folks,
I recently upgraded and erased the startup config on a couple of
asr1001-x routers that are being repurposed. Standard procedure,
though this is the first time I have used the 1001-x specifically.
Upon reboot I was expecting a "Router>" prompt, but instead I'm
presented with a "Username:" prompt that does not allow me to log in
with any of the local users or passwords that would have been in the
config on this router.
So, I boot into rommon, run "confreg 0x2142" and reboot the router.
Upon reboot, the same "Username:" prompt shows up. I figure my
settings in rommon didn't stick so I check them and verify that
confreg really is set to 0x2142.
This exact same issue is present on two different asr1001-x routers
which leads me to believe that there must be something in the 1001-x
docs about password recovery that I'm missing.
Has anyone ever seen this, and if so could you point me to
documentation that shows how to fix it? I have never seen anything
like it and I'd rather not have to go through TAC if this is simple to
fix.
From what code did you upgrade, and to what?
Mark.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
