Hello, I'm trying to leak routes from my main routing table to a VRF. Using Cisco IOS XE Software, Version 16.09.05 on a ASR1001-X
I've done this config : ip prefix-list BT_LNS-out seq 5 permit x.x.x.3/32 ip prefix-list BT_LNS-out seq 10 permit x.x.x.4/32 ip prefix-list BT_radius-out seq 5 permit x.x.x.5/32 ip prefix-list BT_radius-out seq 10 permit x.x.x.6/32 route-map BT_bgp-out permit 10 match ip address prefix-list BT_LNS-out BT_radius-out ip vrf interco_BT rd 12844:1 import ipv4 unicast map BT_bgp-out ip route x.x.x.3 255.255.255.255 Loopback0 ip route x.x.x.4 255.255.255.255 <next-hop> ip route x.x.x.5 255.255.255.255 <next-hop> ip route x.x.x.6 255.255.255.255 <next-hop> so my main routing table has routes to x.x.x.[3-6]/32 but I'm unable to see the routes in the VRF "interco_BT". Tried to add route in the vrf : ip route vrf interco_BT x.x.x.3 255.255.255.255 loopback 0 % For VPN or topology routes, must specify a next hop IP address if not a point-to-point interface I guess I'm missing something. Can somebody tell my where I am wrong please ? Thank you. Regards, Cédric _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
