Hi, this is a little bit off-topic but perhaps someone solved this already:
Regarding Cisco WLAN-Controllers and CAPWAP Access-points, I am seeking the snmp way to get the "NAT External IP Address" shown in the CLI output (and also visiblae in the web-interface): (Cisco Controller) >show ap config general JM-TEST Cisco AP Identifier.............................. 19 Cisco AP Name.................................... JM-TEST Country code..................................... DE - Germany [...] MAC Address...................................... 7c:69:f6:04:9a:e2 IP Address Configuration......................... DHCP IP Address....................................... 192.168.33.169 IP NetMask....................................... 255.255.255.0 Gateway IP Addr.................................. 192.168.33.254 NAT External IP Address.......................... 21X.1X6.1X3.1XY:1481 CAPWAP Path MTU.................................. 1485 [...] I think it may bee in the CISCO-LWAPP-TUNNEL-MIB but a snmpwalk fails "index not increasing" And many Variables are "NOT ACCESSIBLE" marked ind the .my file (and I do not know hov to use an unknow octett-string as an index) . Thank you for any ideas, Jürgen. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
