I believe the OP was about interop between cisco and juniper using key-chains.
On Wed, Jun 3, 2020 at 1:56 AM Phil Bedard <[email protected]> wrote: > There shouldn't be an issue using keychains for these functions, I have XR > and XE devices running IS-IS between each other with keychains on both > without an issue. > > One thing to always watch out for is inadvertent spaces after you type in > a clear text password. > > Thanks, > Phil > > On 5/28/20, 3:44 AM, "cisco-nsp on behalf of Mark Tinka" < > [email protected] on behalf of [email protected]> > wrote: > > > > On 27/May/20 21:08, Eric Van Tol wrote: > > Unless I get suggestions otherwise, I suppose I'll just not use > keys, which seems prohibitive, particularly if a password needs changing at > some point. The 'lsp-password' without a key chain seems to work just fine. > :-/ > > In IOS and IOS XE, we use key chains. > > In IOS XR, we use "lsp-password hmac-md5" at the "router isis" level, > and "hello-password hmac-md5" at the "router isis 1 interface" level. > > Mark. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
