Are you using a span session? If so - then you cannot run SFLOW at the same time.
Is this a GEN1 or GEN2 9300? EX or FX? -----Original Message----- From: cisco-nsp <[email protected]> On Behalf Of Satish Patel Sent: Friday, April 5, 2019 3:15 PM To: Cisco Network Service Providers <[email protected]> Subject: [c-nsp] Cisco Nexus 9K tcam carving question This message originates from outside of your organisation. Folks, I want to enable sFlow on Cisco nexus 9300 switch on 40G interface (GEM) module. but getting following error. (config)# sflow data-source interface e2/5 In order to enable sFlow sampling on North star front panel port(Ethernet2/5), please either carve both span and sflow tcam regions with non-zero sizes using the commands 'hardware access-list tcam region span <size>' 'hardware access-list tcam region sflow <size>' or remove both span and sflow tcam regions and carve a span-sflow tcam region with a non-zero size using the commands When i am doing following, got error that means i don't have space in my tcam table so what is the best approve here? (config)# hardware access-list tcam region sflow 256 ERROR: Aggregate TCAM region configuration exceeded the available Ingress TCAM slices. Please re-configure. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
