Config snippet from both routers CE R1 interface GigabitEthernet0/0/3 description POP1-CE02 3750SW-1 mtu 1600 no ip address media-type rj45 negotiation auto service instance 1 ethernet description L2 Extension LAN encapsulation dot1q 229,232 xconnect 100.66.50.110 100 encapsulation l2tpv3 pw-class L2TPv3 ! service instance 2 ethernet description Corporate L3 LAN encapsulation dot1q 700 rewrite ingress tag pop 1 symmetric bridge-domain 4 ! CE R2 interface GigabitEthernet0/0/3 description POP2-CE02 3750SW-1 mtu1600 no ip address negotiation auto service instance 1 ethernet description L2 Extension LAN encapsulation dot1q 229,232 xconnect 100.66.50.109 100 encapsulation l2tpv3 pw-class L2TPv3 ! service instance 2 ethernet description Corporate L3 LAN encapsulation dot1q 700 rewrite ingress tag pop 1 symmetric bridge-domain 4 ! !
On Fri, 7 Dec 2018 at 18:04, Richard Clayton <[email protected]> wrote: > Hi Guys > > I have two main sites, HQ and DR, the site has layer 2 p2p between them > and a 4431 on each for the WAN. They want layer two backup over the 4431 > WAN circuits for their existing layer 2 p2p. > I have tested L2TPV3 xconnect inside LAN facing Service Instance, the > L2TPV3 session establishes, but is not passing and frames. My question. > Is L2TPV3 xconnect inside a Service Instance supported on 4431 IOS XE, or > do I need to change my lab to either OTV or VXLAN? > > I have the AppX license installed on both routers. > > Thanks in advance of you assistance. > > Rick > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
