On 19/May/16 16:04, Lukas Tribus wrote:
> 8 GB RAM would be enough even if you had a full BGP table. We just max. it out and forget about it. That said, a 16GB RP will report 8G for use. See below: cisco ASR1006 (RP2) processor (revision RP2) with *9877599K/6147K* bytes of memory. Processor board ID FXS1813Q21G 2 Ten Gigabit Ethernet interfaces 32768K bytes of non-volatile configuration memory. *16777216K* bytes of physical memory. 1884159K bytes of eUSB flash at bootflash:. 78085207K bytes of SATA hard disk at harddisk:. 15856K bytes of obfl at obfl:. Configuration register is 0x2102 Mark. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
