show ip bgp nei xyz received-routes will give you the routes as you received them _before_ your own filtering. Use show ip bgp nei xyz routes instead.
Regards, Fredrik On 10 March 2015 at 03:40, CiscoNSP List <[email protected]> wrote: > Hi Everyone, > > Only had a few hours sleep, so I may be overlooking something extremely > obvious...but we are receiving a default from a customer, even though > route-map/prefix list *should* block it... > router bgp xxx > ... > address-family ipv4 > ... > neighbor CUST_A route-map CUST_A-BGP-IN in > > ip prefix-list PL_DENY_DEFAULT seq 5 permit 0.0.0.0/0 > ip prefix-list PL_CUST_A_BGP_PREFIXES seq 5 permit xxx.xxx.xxx.0/24 > > route-map CUST_A-BGP-IN deny 5 > match ip address prefix-list PL_DENY_DEFAULT > route-map CUST_A-BGP-IN permit 10 > match ip address prefix-list PL_CUST_A_BGP_PREFIXES > set community xxxxx:1400 > > Weird thing is, that "sh ip bgp summary" shows that neighbour as only > having 1 in "State/PfxRcd" > > but "sh ip bgp nei xxx.xxx.xx.xx received-routes" shows the neighbour with > 0.0.0.0 and there single /24 > > Cheers for any help. > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
